Project: 5757 (Run 6, Clone 108, Gen 25)

[Edboard]

Code: Select all

[12:39:07] Project: 5757 (Run 6, Clone 108, Gen 25)
[12:39:07] 
[12:39:07] Assembly optimizations on if available.
[12:39:07] Entering M.D.
[12:39:14] Working on Protein
[12:39:14] Run: exception thrown during GuardedRun
[12:39:14] Run: exception thrown in GuardedRun -- Gromacs cannot continue further.
[12:39:14] Going to send back what have done -- stepsTotalG=0
[12:39:14] Work fraction=0.0000 steps=0.
[12:39:18] logfile size=0 infoLength=0 edr=0 trr=23
[12:39:18] - Writing 635 bytes of core data to disk...
[12:39:18] Done: 123 -> 124 (compressed to 100.8 percent)
[12:39:18]   ... Done.
[12:39:18] 
[12:39:18] Folding@home Core Shutdown: UNSTABLE_MACHINE
[12:39:21] CoreStatus = 7A (122)
[12:39:21] Sending work to server
[12:39:21] Project: 5757 (Run 6, Clone 108, Gen 25)
[12:39:21] - Read packet limit of 540015616... Set to 524286976.

I'm getting continuosly this error and finally Folding stops 24 hours....
Then I stop folding a restart it, and after some tryings, it gets a 5506 and it works fine.

[toTOW]

You're the only one to have submitted a partial result for this WU (it was an immediate EUE).

[Edboard]

I have the same kind of errors wiht others too, like this one: Project: 5764 (Run 3, Clone 80, Gen 13)
But when it load 5506, no problem.

It is an 8800 GT 512 running in a Vista Home Premium computer as a second graph card, the first one is a 280GTX and this one works without problem. It has an 10% OC in clock and shaders. I'm now letting it at stock clocks. Before these kind of units it works fine, but now...

[Edboard]

I have a problem with this graphic card and any 575x work unit. I have updated to Nvidia 180.48 drivers and I have tried without OC and with underclocking, but it always do error. The gtx280 runs Ok. Tomorrow I will try to update the client to 6.23 (now I have 6.20).

[toTOW]

Latest official driver is 180.60 : http://www.nvidia.com/object/cuda_get.html

Did you try it ?

[anko1]

I haven't had any errors to speak of in the 57xx series. I have two cards: 1) an NVIDIA Quadro FX-3700 w/ Windows XP Service Pack 3, FAH 6.20r1, and a 9800GTX R w/same windows and FAH program.

[Edboard]

Latest official driver is 180.60 : http://www.nvidia.com/object/cuda_get.html

Did you try it ?

No. I didn't know it. I'll try it first.

EDIT: I have just seen this thread: "New jobs and requiremens of core 1.19, loss of dual gpu" and I have realised that this must be my problem.