Not returning workunits

[rysk]

Hi,

I couldn't figure out a way to cancel a work unit or if this is even an option, but I just wanted to make the admins aware that I will not be returning the following work units, because I had to format my computer.
P6301 (R451, C2, G19)
P6302 (R255, C3, G16)
P1750 (R3, C99, G0)
P6302 (R683, C3, G19)

Rysk

[DanGe]

Hi,

I couldn't figure out a way to cancel a work unit or if this is even an option, but I just wanted to make the admins aware that I will not be returning the following work units, because I had to format my computer.
P6301 (R451, C2, G19)
P6302 (R255, C3, G16)
P1750 (R3, C99, G0)
P6302 (R683, C3, G19)

Rysk

Unfortunately there is no way to cancel a work unit, so the servers won't reassign it until the preferred deadline passes.
Next time, you could use the -oneunit flag to stop the client once it finishes a work unit so you won't run into this again.