Project: 8001 (Run 3, Clone 51, Gen 24) - Faulty?

[Joe_H]

This WU exited immediately on starting, just checking to see if it is bad or someone else does complete it successfully. Machine is not overclocked, has had the dust bunnies removed, and previously had done a couple hundred other Project 8001 units. Went right back to folding them afterwards.

Code: Select all

16:42:24:Unit 01:Project: 8001 (Run 3, Clone 51, Gen 24)
16:42:24:Unit 01:
16:42:24:Unit 01:Assembly optimizations on if available.
16:42:24:Unit 01:Entering M.D.
16:42:29:Unit 00: 42.86%
16:42:30:Unit 01:Mapping NT from 8 to 8 
16:42:30:Unit 01:mdrun returned 255
16:42:30:Unit 01:Going to send back what have done -- stepsTotalG=250000
16:42:30:Unit 01:Work fraction=4294967296.0000 steps=250000.
16:42:34:Unit 01:logfile size=6864 infoLength=6864 edr=25 trr=1
16:42:34:Unit 01:logfile size: 6864 info=6864 bed=25 hdr=1
16:42:34:Unit 01:- Writing 7402 bytes of core data to disk...
16:42:34:Unit 01:Done: 6890 -> 2477 (compressed to 35.9 percent)
16:42:34:Unit 01:  ... Done.
16:42:34:Unit 01:
16:42:34:Unit 01:Folding@home Core Shutdown: UNSTABLE_MACHINE
16:42:34:FahCore, running Unit 01, returned: UNSTABLE_MACHINE (122 = 0x7a)
16:42:34:Sending unit results: id:01 state:SEND error:FAULTY project:8001 run:3 clone:51 gen:24 core:0xa4 unit:0x000000246652edca4eded77c017da8cb
16:42:34:Unit 01: Uploading 2.92KiB to 171.67.108.58
16:42:34:Connecting to 171.67.108.58:8080
16:42:34:Connecting to assign3.stanford.edu:8080
16:42:35:Unit 00: 88.81%
16:42:35:News: Welcome to Folding@Home
16:42:35:Assigned to work server 171.67.108.58
16:42:35:Requesting new work unit for slot 00: READY smp:8 from 171.67.108.58
16:42:35:Connecting to 171.67.108.58:8080
16:42:36:Unit 01: Upload complete
16:42:36:Server responded WORK_ACK (400)
16:42:36:Cleaning up Unit 01

iMac 2.8 i7, 12 GB RAM, OS X 10.6.8, 7.1.38beta

[PantherX]

Your result:

Hi Joe_H (team 38910),
Your WU (P8001 R3 C51 G24) was added to the stats database on 2011-12-27 09:09:15 for 0 points of credit.

There were multiple failures in the WU Database so I have marked it as a bad WU:

The WU (P8001,R3,C51,G24) has been reported as a bad WU.

Thanks for your report.