Project: 3065 (Run 5, Clone 323, Gen 41) crashes at 26%

[adilms]

This was running over the weekend and crashed two times at the same point.

I just got back home and shut down the terminal (i'm running Mac OSX Leopard console smp client) and started it again around 22%.

I believe this is the work unit name: ''66728 p3065_lambda5_99sb_big'. It's the name after the "mdrun" command.

The error I got first is:

Code: Select all

[13:52:04] Completed 625000 out of 2500000 steps  (25 percent)
[14:27:06] Writing local files
[14:27:07] Completed 650000 out of 2500000 steps  (26 percent)
[14:42:09] Warning:  long 1-4 interactions
[14:42:14] CoreStatus = 0 (0)
[14:42:14] Sending work to server
[14:42:14] Project: 3065 (Run 5, Clone 323, Gen 41)
[14:42:14] - Error: Could not get length of results file work/wuresults_07.dat
[14:42:14] - Error: Could not read unit 07 file. Removing from queue.
[14:42:14] - Preparing to get new work unit...
[14:42:14] Cleaning up work directory

Then again for the same work unit:

Code: Select all

[05:40:38] Completed 625000 out of 2500000 steps  (25 percent)
[06:16:07] Writing local files
[06:16:07] Completed 650000 out of 2500000 steps  (26 percent)
[06:29:54] Warning:  long 1-4 interactions
[06:29:59] CoreStatus = 0 (0)
[06:29:59] Sending work to server
[06:29:59] Project: 3065 (Run 5, Clone 323, Gen 41)
[06:29:59] - Error: Could not get length of results file work/wuresults_08.dat
[06:29:59] - Error: Could not read unit 08 file. Removing from queue.
[06:29:59] - Preparing to get new work unit...
[06:29:59] Cleaning up work directory

I'm competing with my buddy Bill and it's neck and neck. I want to get some points, keep it fun. I've finished another work units on the same computer, from the same project with no problems... 3065 (Run 4, Clone 156, Gen 73)

[bruce]

Nobody has completed that WU yet, and since your client isn't uploading a result that's not particularly surprising. It sounds like it might be a bad WU, but I'll wait until somebody else reports it.