Force RMSE error, p17717
Posted: Sun Mar 07, 2021 9:38 pm
I just noticed the following error on one of my systems and I hope sharing it here is useful:
After looking for the specific unit on the WU Status page, I found out that I'm not the only one.
I already found the following answer:
Code: Select all
21:06:40:WU02:FS00:0x22:ERROR:Force RMSE error of 6.1443 with threshold of 5
21:06:40:WU02:FS00:0x22:Saving result file ..\logfile_01.txt
21:06:40:WU02:FS00:0x22:Saving result file science.log
21:06:40:WU02:FS00:0x22:Saving result file state.xml
21:06:41:WU02:FS00:0x22:Folding@home Core Shutdown: BAD_WORK_UNIT
21:06:41:WARNING:WU02:FS00:FahCore returned: BAD_WORK_UNIT (114 = 0x72)
21:06:41:WU02:FS00:Sending unit results: id:02 state:SEND error:FAULTY project:17717 run:24 clone:0 gen:44 core:0x22 unit:0x000000000000002c0000453500000018
21:06:41:WU02:FS00:Uploading 6.75MiB to 128.174.73.74I already found the following answer:
bruce wrote:The RMSE error message is from the part of the FAHCore that validates that the WU is coherent and is intended to stop processing if there has been a gross error before you waste a lot of time just to have the WU discarded later. The threshold of 5 is supposed to allow for floating point truncation errors and other factors where the calculations are "close enough" vs. "Wrong"
Obviously 6.7 is only a little too much error, but you have to set a threshold somewhere.
.. posting here doesn't help beta progress 