Folding Forum

Hello, I'm pretty new to FAH, so excuse me if this is a basic question.

I installed FAH on my system with a i7-6700k, GTX-970, and GTX-1070. The first time I ran FAH, it showed my 1070 and processing, but the 970 and i7 were stuck on ready. I googled around, and after re-installing the 970 was processing, but the other two were stuck on ready. I tried removing and adding all the slots, but it didn't seem to help. Any suggestions?

I doubt there's anything you can/should do except be patient and read the other recent reports on this forum.

Hi

The servers that are handling the issuing of work units are very heavily loaded. New servers are in the process of being brought online but its taking time. The situation is a lot better than it was a couple of days ago so please be patient.

Ok, so this is a WU problem and not a config problem? If that's the case than it's no big deal, I just didn't know if it was setup right.

Post the first 200 lines of the log and we can check to see if its a config issue but it sounds like you are in the logjam of WU requests

Actually I forgot I had FAH running and about a minute ago I heard all my computer fans kick on. I checked, and sure enough all my devices were being used. It was definitely the WU logjam