Folding Forum

UPDATE:

After successfully finishing the P6900 the client went back to 232.237 and went into a five hour loop of downloading the same bad 512 byte WU [P6901 (R12, C4, G130)].

I deleted queue.dat, unitinfo.txt, work/*.*, and machinedependent.dat and the client immediately picked up a different P6901 and started folding.

Can someone please stop this bad WU? It's killing production!

Mod Note: This is an update to posts by bollix in this topic

Thank you for the report on your problems with Project: 6901 (Run 12, Clone 4, Gen 130). I did check that one and, thus far, this is the only report I have seen on it. I will mark it for followup.

For the 512 byte WU error, please see this thread : viewtopic.php?f=18&t=20523

This WU has been completed by three different donors at this point, so I will close the report now.