Folding Forum

I have two rigs that have been getting these wu's in this range and both will have the Fahcore a5 has stopped working in Windows. I get this error when rigs are overclocked and both at stock speeds. I have folded other 2684 wu's without issues but when i get any of these i get that error. Also when i got up this morning i checked my rigs and two rigs had downloaded to the same wu (R, C, G) and both had the fahcore a5 has stopped working error. The wu doesnt even get past 0%. Once it starts to initiate and threads start to go to 100% it gets the error.
Not sure what else to do and why only these wu's i am getting the error on.

Sorry if this is confusing to some but its early and i just woke up.

It sounds like it is a bad WU you may want to report the Run () Clone () and Gen () if boyh machines are hanging in the same spot on the same WU.

How do I report a wu?
Also it was the same on both machines today but yesterday it was the same run, clone but the gen was 100.
I'm not sure what's going on with them but they are unable to fold on stock speeds on either rig.

You report it just like you did here but you need to include the Run, Clone and Gen numbers (IE) Project 2684 (Run 1 Clone 2 Gen 3) then the mods will mark it so it can be watched for and or marked as a bad WU if it fails on other machines then it will be removed from the servers.

I updated the title to reflect the wu that i am having issues with. It downloaded again today and ran into the exact same issues i have been having.

Thanks for the report since it is a bad WU for many donors. It has been reported as a bad WU:

The WU (P2684,R0,C23,G104) has been reported as a bad WU.