Page 1 of 1

Changing team name and number

Posted: Mon Jan 18, 2010 11:28 pm
by StudentDan
Hello everyone. Any help on changing team name and number when using a VM and Linux? I have instructions for doing this but they don't work. I am stuck folding for team "notfred" I want to fold for overclock. My GPU folding is going good,no problems. Thanks

Re: Changing team name and number

Posted: Mon Jan 18, 2010 11:48 pm
by bollix47
I have instructions for doing this but they don't work.
Are these the instructions you've tried to use?
The system will start up and run with default settings, point a web browser at the specified IP address and hit the "Reconfigure this host and any USB drives." link to reconfigure it and then hit the "Remote reboot: enabled" link to get it to pick up the new configuration.
If so, what part didn't work for you?

Re: Changing team name and number

Posted: Tue Jan 19, 2010 1:22 am
by 7im
Notfred is a member at the Tech Report forum, and doens't visit here much. If the instructions don't work, try posting over there so he can help you.

Re: Changing team name and number

Posted: Tue Jan 19, 2010 9:23 pm
by StudentDan
Thanks guys, I managed to get my correct team and name added to my VM but when I check "stats" inside of Fahmon I am taken to the Tech Report stats page. I will do as instructed and move to The correct Forum with my "stats" question

Re: Changing team name and number

Posted: Wed Jan 20, 2010 1:22 am
by StudentDan
Just wanted to say issue worked its self out. It was a first WU submission then correct team and name appeared. Had to do a "split screen" activation of "configure" on folding parameters page and my VM "restart", so I had two problems, one worked its self out, the other I had too take only minimal action. Thanks