Page 2 of 2
Re: Remote access not working
Posted: Fri Mar 27, 2020 9:47 am
by JacquesVoogt
I have the IP addresses specified in both.
It is not a big issue. It runs on multiple servers in my garage. I just need to be mindful when I restart them to manually stop, kill and start again.
As long as they keep running and churning out folds they will likely not be restarted at all.
Re: Remote access not working
Posted: Sat Mar 28, 2020 12:41 am
by Joe_H
Teacfreak wrote:I'm new and have three machines running. One W10 and two Debian headless, while the W10 should also show the two headless systems.
I followed the discussion here but it seems that the "command port" 36330 is only open on the local 127.0.0.1 device. Connecting to the external device, even from the specific machine itself, telnet connection fails.
So how can I activate the external port? I did an all machines the standard installation with no custom config, except the account information of course.
Did you restart all systems' FAHClient process or reboot them after adding the necessary network addresses and the optional password? If you don not add a password for use on your own LAN, you need to add the addresses allowed to access without a PW.
Re: Remote access not working
Posted: Sat Mar 28, 2020 1:00 am
by lostcowboy
Re: Remote access not working
Posted: Sun Mar 29, 2020 12:48 pm
by Michael Mrak
Great, thanks for the videolink!