Re: Remote Monitoring?
Posted: Sat Mar 02, 2013 9:29 pm
It was a default 7.2.9 install in the default directory on a Win7-64 folding SMP16 + GPU. I did the Remote changes while it was folding.
The reason FAHControl could not edit the necessary lines of the Config file, was because it must be "connected" to the local machine (127.0.0.1) first. If it isn't, the Config button will launch, however the only page to edit is the USER info, not the remote, or slots. etc. Even when I manually edited it, removing all the remote info, nothing changed.
While the machine is still folding OK, it starts to fill the log with SCANNING PORT xxxxx, in a steady stream, only occassionally interrupted by the actual log progress lines.
But the point is moot, I could not allow it keep running that way, so I uninstalled all, then reinstalled.
The reason FAHControl could not edit the necessary lines of the Config file, was because it must be "connected" to the local machine (127.0.0.1) first. If it isn't, the Config button will launch, however the only page to edit is the USER info, not the remote, or slots. etc. Even when I manually edited it, removing all the remote info, nothing changed.
While the machine is still folding OK, it starts to fill the log with SCANNING PORT xxxxx, in a steady stream, only occassionally interrupted by the actual log progress lines.
But the point is moot, I could not allow it keep running that way, so I uninstalled all, then reinstalled.