Folding Forum

Thanks... for the purposes of my testing, I set all 3 clients to CPU:32.

So what's the general recommendation for SMP? Should I stick to cpu:30 and above just based on PPD alone? I'm not going to dig too far into the optimizations, because I'm typically a 30k ppd contributor anyway... A single one of these blades matches my normal daily output... and I can only run them ...

That's low, you do have a passkey don't you? Are the cpu's staying in turbo mode or are they dropping into power saving mode? For reference a dual L5640 xeon setup 12c/24t @ 2.4 gets ~50k PPD on any core A3 project and 46-49k on a core A4 project I do have a passkey, and it is configured. These are...

Hi all, I'm looking to do some stress testing on my new HP BL465 servers, and was trying to figure out what the best configuration would be. I'm only going to have the servers available for about a week, but was hoping to contribute some to the project while they're burning in. I have three blades, ...

I've been getting Core 17 units randomly... Seems to be every 3rd WU or so. I just got one a little bit ago, but for the last two days my GPU had been working through a Core 15 unit. See #2 from 7im in this thread: And not getting core 17 does not indicate a lack of those WUs. It indicates core 15 ...

I've been getting Core 17 units randomly... Seems to be every 3rd WU or so. I just got one a little bit ago, but for the last two days my GPU had been working through a Core 15 unit.